Wraparound Sleeve for Offshore Heated Infill Systems MIS-65 and MIS-100 heat-shrinkable sleeves provide superior corrosion protection and effective long-term adhesion to pipelines operating offshore at temperatures up to 100°C (212°F). MIS-65 and MIS-100 sleeves are specifically engineered for use in combination with hot marine mastic pour, polyurethane foam or other infill systems. MIS-65 and MIS-100 sleeves are resistant to the severe conditions of hot mastic pour operations and maintain their full set of anti-corrosion properties. MIS-65 and MIS-100 are fully compatible with a wide range of pipeline coatings, including PP, FBE, PE, Coal Tar and Tape. • Patented one-piece construction that incorporates a pre-attached closure seal for rapid and consistent field installation procedure • Lower pre-heat temperature contributes to lower installation times • Fast and efficient field installation in-line with timing requirements of offshore laybarge operations • Superior adhesion to a wide range of mainline pipe coatings • Consistent performance in rugged offshore environments • Compatible with hot mastic pour, polyurethane foam or other infill systems Offshore Oil and Gas Infill Systems   Reel, J & S Lay Girth-Weld Joints     Wrapid Sleeve™ 2-Layer Standard Shrink   55-1220 (2"-48") up to 100°C (212°F)   These documents are in PDF format. To download other languages or the Adobe Acrobat reader, please visit the All Literature section. Product Data Sheets MIS-65 & 100 PDS (8.5" x 11") MIS-65 & 100 PDS (A4) Installation Guides MIS-65 & 100 IG (8.5" x 11") MIS-65 & 100 IG (A4)