Shrink sleeve products for girth-weld protection of elevated operating temperature pipelines A group of heat-shrinkable products that provide superior corrosion protection (2-layer or 3-layer) of girth-weld joints of buried, exposed and hot infill pipelines operating up to 80°C (176°F). The products can be supplied in various configurations (CanusaWrap™ or Wrapid Sleeve™). Epoxy primers are used for 3-layer joint systems. • Unique adhesive technology allows for lower installation temp pre-heats with/out epoxy • Products are available in various configurations to meet project installation requirements • Superior corrosion protection when epoxy primer (E Primer or P Primer) is “force-cured” and pre-inspected on steel only • High stress strength adhesives pass Aleyska Shear Test at maximum operating temperature • The same pre-heat temperature with or without epoxy minimizes installation procedure issues • Epoxy is applied to steel only, which results in lower material and labour costs • “Force-cured” epoxies enable the joints to be pre-inspected prior to sleeve application and will not be displaced during sleeve alignment and recovery Oil and Gas Polypropylene Offshore   Wrapid Sleeve™ CanusaWrap™ 2-Layer 3-Layer 55-1520 (2"-60")       up to 80°C (176°F)       SNAM, Gaz de france, Trans Canada, Gazprom These documents are in PDF format. To download other languages or the Adobe Acrobat reader, please visit the All Literature section. Product Data Sheets S Primer PDS (8.5" x 11") S Primer PDS (A4)