Multi-Layer Sleeve System For Directional Drilling Canusa’s TBK - Directional Drilling Kit is a high performance system designed to protect welded joints on 2 and 3-layer PE, PP and FBE coated pipelines in directional drills. The system consists of three components: a primary heat-shrinkable sleeve which provides corrosion protection at the joint; a secondary heat-shrinkable sleeve which functions as a sacrificial wear cone; and a high-build epoxy top coat at the ends to provide additional protection to the system. An optional epoxy primer is also available for 3-layer systems. The system provides effective protection against abrasion and wear forces that occur during the pull-through operation. The system is fully compatible with cathodic protection systems, resists cathodic disbondment and is designed for a wide range of operating temperatures. • High performance system that consists of a primary heat shrinkable sleeve for corrosion protection, a sacrificial heat- shrink sleeve for wear cone and epoxy for direct-to-steel corrosion protection and mechanical overcoat • Sleeves are supplied as Wrapid Sleeves™ • Epoxy is supplied in pre-measured kits Oil and Gas Water Directional Drilling Girth-Weld Joints Polypropylene       2-Layer 3-Layer Force-Cure Epoxy   Multi-Sleeve Kit Wrapid Sleeve™     55-1520 (2"-60") up to 140°C (284°F) These documents are in PDF format. To download other languages or the Adobe Acrobat reader, please visit the All Literature section. Product Data Sheets TBK PDS (8.5" x 11") TBK PDS (A4) TBK-60 PDS (8.5" x 11") TBK-60 PDS (A4) TBK-PP PDS (8.5" x 11") TBK-PP PDS (A4) TBK XL-65 PDS (8.5" x 11") TBK XL-65 PDS (A4) Installation Guides TBK IG (8.5" x 11") TBK IG (A4) TBK-60 IG (8.5" x 11") TBK-60 IG (A4) TBK-PP IG (8.5" x 11") TBK-PP IG (A4) TBK-PP-65 IG (8.5" x 11") TBK-PP-65 IG (A4) TBK XL-65 IG (8.5" x 11") TBK XL-65 IG (A4)